INSTALLATION
Check the appliance is electrically safe and gas sound when you have finished.
actual opening of the doors is slightly less but this allows for some protection of your hand as you open the door.
Unpacking the Cooker
Do not take any packaging off the cooker until it is directly in front of the place it is to be installed (unless it will not fit through a door in its outer packaging).
Cut the banding straps and lift the cardboard box off the cooker, leaving the cooker standing on the base packaging. See the loose unpacking sheet.
Moving the Cooker
The cooker is very heavy. Take great care.
We recommend two people manoeuvre the cooker. Ensure that the floor covering is firmly fixed, or removed to prevent it being disturbed when moving the cooker around. You will need the levelling tool.
From the back tilt the cooker forward and remove the rear half of the polystyrene base pack.
Repeat from the front and remove the front half of the poly base. Pull the drawer out to its furthest point.
Find the hexagon headed adjusters at each front corner of the cooker.
Use the levelling tool to turn the 2 adjusting nuts, one at each of the front bottom corners of the cooker.
Turn both 10 complete turns clockwise to lower rear rollers.
Open the grill door and Warmer compartment door. With your hands under the bottom edge of the hot plate facia, lift the front of the cooker slightly and then roll the cooker on the rollers.
Do not use the door handles or control knobs to move the cooker.
Take care not to twist it within the gap between the kitchen units as damage may occur to the cooker or the units.
Levelling
Place the cooker in its intended position taking care not to twist it within the gap between the kitchen units as damage may occur to the cooker or the units.
The rear rollers and front feet can be adjusted to level the cooker. To adjust the height of the rear of the cooker use the levelling tool supplied to turn the adjusting nuts at the front bottom corners of the cooker.
To adjust the height of the front of the cooker screw down the front feet.
Fitting a stability bracket
A stability bracket or chain (not supplied by with the cooker) should be fitted when the cooker is connected to a flexible gas supply.
When fitting a stability bracket read these instructions together with the leaflet supplied with the bracket.
26
