Maytag 110 Conversion to LP gas, Jets, Stick on label, Pressure Testing, Tap Bypas screws

INSTALLATION

Check the appliance is electrically safe and gas sound when you have finished.

Conversion to LP gas

Check in the Technical Data section at the back of the book that the cooker is convertible to the gas you want to use.

This conversion must be performed by a competent person. After conversion the installation must comply with the relevant regulations and also the local electricity supply company requirements. Read the instructions before converting this appliance.

Failure to convert the appliance correctly could invalidate any warranty or liability claims and lead to prosecution.

This instruction must be used in conjunction with the rest of the appliance instruction, in particular for information on Standards, cooker positioning, connection hose suitability etc.

When servicing or replacing gas-carrying components disconnect from gas before commencing operation and check appliance is gas sound after completion.

Do not use re-conditioned or unauthorised gas controls.

Disconnect from the electricity supply before commencing servicing. Before electrical re-connection, check that the appliance is electrically safe.

Jets

Remove burner caps and heads. Remove old jets. Fit new jets (see the table for the correct jets). Reassemble in reverse order.

Lift the control panel, pull forward and disconnect the wiring from the rear.

A tap bypass screw

Remove the tap bypass screw and replace with the correct screw. See the table for the correct bypass screws.

Stick on label

Stick the appropriate label on to the data badge to indicate the gas the appliance is now set for.

Pressure Testing

Connect the appliance to the gas supply. Check the appliance is gas sound.

The gas pressure can be measured at one of the hotplate burner jets (NOT a Wok burner). Make sure that the cooker is not connected to the electricity supply. Lift off

a burner head. Fit the pressure gauge to the jet. Turn on one of the other burners and light it with a match. Turn on the control for the hotplate burner to which the pressure gauge is fitted. Press in the knob to allow the gas through and register the pressure on the gauge.

After checking the pressure, turn the taps off and replace the burner head.

Reassemble burner top, making sure it is reassembled in the correct way on the burner body.

Tap Bypas screws

Pull off all the control knobs.

Open the oven doors and remove the 2 fixing screws, one at each end, underneath the control panel.

Pull off the push fit control panel end caps at each end and remove the end fixing screws under the end cap.

Check the appliance is gas sound.

Check operation of all the burners.

Check that the appliance is electrically safe.

	Natural Gas 20mb			L.P. Gas
Hotplate		Injector	Screw		Injector	Screw
Wok burner	3.5kW	internal 80	96	3.5kW (246g/h)	internal 54	57
		external 129			external 77
Large Burner	3.0kW	134	54	3.0kW (210g/h)	87	40
Medium Burners	1.7kW	109	39	1.7kW (119g/h)	68	32
Small Burner	1.0kW	75	38	1.0kW (70g/h)	51	28

29