INSTALLATION
Check the appliance is electrically safe and gas sound when you have finished.
1.Place the cooker in its intended position and level the appliance.
2.Draw a pencil line 100mm from the front edge of the levelling feet.
3.Mark the centre line for the bracket by measuring 550mm from the L.H. side of the cooker.
4.Remove the cooker.
5.Measure back from the pencil line 535mm to locate the front edge of the bracket. Fix bracket to floor.
6.Measure height from floor level to engagement edge in back of cooker. Add 3mm to this dimension and assemble stability bracket to this height. (i.e. from floor level to underside of top member) and ensure bracket does not foul oven burner assembly.
Gas Connection
Bappliance gas inlet
Because the height of the cooker can be adjusted and each connection is different it is difficult to give precise dimensions. Ideally the house supply bayonet should be in the shaded area shown in the diagram. Although a 900mm hose can be used, a 1250mm hose will allow slightly more flexibility in the positioning of the bayonet and make moving the cooker easier. The hose should be fitted so that both inlet and outlet connections are vertical so that the hose hangs downwards.
The connector is located just below the hotplate level at the rear of the cooker.
For Natural Gas the flexible hose must be in accordance with B.S.669.
If in doubt contact, your supplier.
Screw connect the threaded end of the hose into the gas inlet in the underside of the connector block on the back of the cooker.
After completing the gas connection, check the cooker is gas sound with a pressure test.
Pressure testing
The gas pressure can be measured at one of the hotplate burner jets (NOT a Wok burner). Make sure that the cooker is not connected to the electricity supply. Lift off
a burner head. Fit the pressure gauge to the jet. Turn on one of the other burners and light it with a match. Turn on the control for the hotplate burner to which the pressure gauge is fitted. Press in the knob to allow the gas through and register the pressure on the gauge.
Pressures
Natural Gas | LP Gas cookers |
20mbar. | Butane 29mbar |
| Propane 37mbar |
|
|
A hose is not supplied by with the cooker. Hoses may be purchased at most builders’ merchants.
The Gas supply needs to terminate with a down facing bayonet. The rear cover boxes limit the position of the supply point.
Reassemble burner top, making sure it is reassembled in the correct way on the burner body.
Electrical Connection
This appliance must be installed by a qualified electrician to comply with the relevant Institute of Electrical Engineers (I.E.E.) regulations and also the local electricity supply company requirements.
WARNING: THIS APPLIANCE MUST BE EARTHED
Note
The cooker must be connected to the correct electrical supply as stated on the voltage label on the cooker, through a suitable cooker control unit incorporating a double pole switch having a contact separation of at least 3mm in all poles. This cooker must not be connected to an ordinary domestic power point.
view from the rear
A position for gas supply connector
27
