SERVICING - WARNING
Disconnect from electricity and gas before servicing. Check appliance is safe when you have finished.
11 To Remove a Hotplate Burner Spark Electrode
Remove the pan supports, burner heads and caps. Remove the screw holding the electrode to the burner body. Lift up the electrode and disconnect the lead.
Note
Take care to prevent the ignition wire from falling back through the clearance hole.
Fit the lead to the new electrode and reassemble in reverse order and check correct burner ignition.
12 To Remove an Oven Door
Open the oven door. Support the door and remove the two screws that secure the upper hinge to the front frame of the unit. Remove the door from the lower hinge by lifting slightly and moving it outward.
When fitting new seal, position the seal join at the bottom. Hook the new seal in one of the corner holes of the door, and proceed round the door snapping in each hook in turn.
16 To Adjust the Oven Door Catch Keeper
Open the oven door and slacken the locknut at the keeper base. Adjust the keeper inward or outward as required, until the desired door operation is obtained. Re- tighten the locknut.
17 To Remove the Hotplate Spark Generator
Disconnect the appliance from the electricity supply. Pull the cooker forward to access the cover boxes at the appliance rear. Remove the fixings that secure the cover and lift it clear. Undo the terminal connections noting their positions. Undo the fixings that secure the spark generator and remove the device.
13 To Remove the Oven Outer Door Panel
Open the oven door. Remove the socket headed screws at the sides of the door. Remove the outer door panel. Remove the handle and fit to the new door panel. Fit the replacement panel to the oven inner door.
14 To Remove the Door Latch
Remove the oven outer door panel – see 12. Remove the fixings that secure the latch assembly to the inner door panel. Fit the replacement catch and
15 To Remove the Oven Door Seal
Open the oven door. The seal is held in place by small hooks on the rear face. At the corner pull seal diagonally away from the door centre until that hook is released. Proceed to the next hook and release it in a similar way, and so on. Use force if the hooks are stiff, as the old seal will be discarded.
18 To Remove the Hotplate Electrode Leads
Disconnect from the electricity supply.
Pull the unit forward to access the rear of the appliance. Remove the hotplate - see 2. Remove the cover box and disconnect all HT leads at the generator. Disconnect the lead at the electrode. Pull the sleeved bundle of HT leads up through the rear upright. Pull the appropriate lead from the sleeve and push in the replacement. Replace the leads in the rear upright.
19. To Remove Grill Element.
Disconnect from electricity supply.
Pull cooker forward to gain access to the rear. Remove screws securing the electric cover to the back sheet and remove cover. Remove the 4 terminals connected to the elements noting their position. Remove grill pan from grill chamber. From inside grill compartment remove enamelled front shield from grill roof, 2 screws and washers. Remove 2 screws and washers securing the grill element front support. Remove 1 screw from each of the grill elements and withdraw grill elements from grill chamber. Fit new elements, reassemble in reverse order. Check operation of grill.
20 To Remove the Warmer Chamber Element
Disconnect from electricity supply.
Pull cooker forward to gain access to the rear. Remove the RH cooker side panel see 3.
The heating element is now accessible.
Disconnect element wires and pull the element pad out of the side of the cooker and discard.
Take the new warming element and sandwich it between
the 2 pieces of card supplied with the kit. Squeeze the assembly together and feed into the gap between the two ovens. Remove the two cards starting with the top piece and taking care not to disturb the element. Reconnect element wires.
31
