Important Safety Information
!WARNING
Precautions to be observed before and during servicing to avoid possible exposure to excessive microwave energy, or electrical shock disconnect power to oven.
•Do not operate or allow oven to be operated with door open.
•Make the following safety checks on all ovens to be serviced before activating the magnetron or other microwave source, and make repairs as necessary:
•Interlock operation
•Proper door closing
•Seal and sealing surfaces (arcing, wear, and other damage)
•Damage to or loosening of hinges and latches
•Evidence of dropping or abuse
•Before turning on microwave power for any service test or inspection within the microwave generating compartments, check the magnetron, waveguide or transmission line, and cavity for proper alignment, integrity, and connections.
•Any failed or misadjusted components in the interlock, monitor, door seal, and microwave generation and transmission systems shall be repaired, replaced or adjusted by procedures described in this manual before oven is released to the consumer.
•Check microwave leakage to verify compliance with the federal performance standard should be performed on each oven prior to release to the consumer.
!WARNING
To avoid risk of electrical shock, injury or death; make sure these grounding instructions are followed.
NEMA
©2006 Maytag Services | 16026795 |
Grounding Instructions
!WARNING
Do not remove grounding prong when installing grounded appliance in a home or business that does not have three wire grounding receptacle, under no condition is grounding prong to be cut off or removed. It is the personal responsibility of the consumer to contact a qualified electrician and have properly grounded three prong wall receptacle installed in accordance with appropriate electrical codes.
!WARNING
To avoid the risk of electrical shock or death, do not alter the plug.
!WARNING
To avoid the risk of electrical shock or death, this equipment must be grounded.
This equipment MUST be grounded. In the event of an electrical short circuit, grounding reduces the risk of electric shock by providing an escape wire for the electric current. This oven is equipped with a cord having a grounding wire with a grounding plug. The plug must be plugged into an outlet that is properly installed and grounded.
Consult a qualified electrician or servicer if grounding instructions are not completely understood, or if doubt exists as to whether the equipment is properly grounded.
Do not use an extension cord. If the product power cord is too short, have a qualified electrician install a three- slot receptacle. This oven should be plugged into a separate 60 hertz circuit with the electrical rating as shown in the appropriate drawing. Models operate with a 120 supply voltage. When a microwave oven is on a circuit with other equipment, an increase in cooking times may be required and fuses can be blown.
NEMA
7
