Manuals / Maytag / Kitchen Appliance / Microwave Oven

Maytag 1800 W - 2005 manual General Information, Unpacking Equipment, Equipment Placement

Models: 1800 W - 2005

1 33

Download 33 pages 21.52 Kb

Page 9

General Information

General Information

Unpacking Equipment

•Inspect equipment for damage such as dents in door or dents inside oven cavity.

•Report any dents or breakage to source of purchase immediately. Do not attempt to use oven if damaged.

•Remove all materials from oven interior.

Equipment Placement

•Do not install equipment next to or above source of heat, such as pizza oven or deep fat fryer. This could cause microwave oven to operate improperly and could shorten life of electrical parts.

•Do not block or obstruct air filter. Allow access for cleaning.

•Install on level countertop surface.

A

A

A

Radio Interference

Microwave operation may cause interference to radio, television, or similar equipment. Reduce or eliminate interference by doing the following:

•Clean door and sealing surfaces of oven according to instructions in “Care and Cleaning” section.

•Place radio, television, etc. as far as possible from oven.

•Use a properly installed antenna on radio, television, etc. to obtain stronger signal reception.

A—Allow at least 1½ inches / 3.81 centimeters of clearance around top and sides of equipment. Proper air flow around equipment cools electrical components. With restricted air flow, oven may not operate properly and life of electrical parts is reduced.

©2006 Maytag Services

16026795

9

Image 9

Maytag 1800 W - 2005 manual General Information, Unpacking Equipment, Equipment Placement, Radio Interference

Contents

RFS18MPS P1330209M Service1800 W Countertop Commercial Microwave Ovens This Base Manual covers general informationService Support Center Important Notices for Servicers and ConsumersImportant Information APPROPRIATE SERVICE INFORMATION BEFORE BEGINNING REPAIRSTable of Contents Important Safety Information Important Safety Information SAVE THESE INSTRUCTIONSRecognize this symbol as a SAFETY message 2. READ AND FOLLOW the specificPRECAUTIONS TO AVOID POSSIBLE EXPOSURE TO EXCESSIVE MICROWAVE ENERGY Important Safety InformationSAVE THESE INSTRUCTIONS Important Safety Information Grounding InstructionsTest Procedures 2 Methods WiringServicing of Grounded Products ExplanationGeneral Information Equipment PlacementUnpacking Equipment Radio InterferenceParts and Accessories ServiceModel Identification Microwave Oven DescriptionCondition Troubleshooting ProceduresCause RemedyCondition Troubleshooting ProceduresCheck ResultTroubleshooting Procedures Electronic Models Troubleshooting Procedures Electronic Models Troubleshooting Procedures Electronic Models Trouble 4 Oven operates with little or no heatTroubleshooting Procedures Electronic Models Proper Handling of Magnetron Tubes Service InformationMagnetron Failure Modes 1. ShortedProcedure for Measuring Radiation Leakage Microwave Leakage TestingEquipment Measurement with the Outer Panel RemovedRadiation Monitors Filament Testing Proceduresmodule, reconnect wires to switch Testing ProceduresAfter verifying or replacing the and check operation of monitor circuitProbe Placement Testing ProceduresSetting FunctionProcedure Power TestTesting Procedures Minimum Temperature Rise at Thirty -Three 33 Seconds Run TimeDisconnecting Wire Terminals Disassembly ProceduresOuter Case DO NOT PULL ON WIREDoor Disassembly Door AssemblyDisassembly Procedures Door RemovalControl Panel Interlock SwitchesDisassembly Procedures NO Primary SwitchDisassembly Procedures High Voltage CapacitorAdjusting Interlocks Bottom Magnetron High Voltage Capacitor RemovalDiode/Circuit Protector Fuse / Fuse Block / Filter AssemblyTransformer MagnetronSplatter Shield Blower MotorTop Antenna Bottom AntennaMagnetron Thermal Cut-Out TCO Tray ReplacementOven Light Removal Cavity Thermal Fuse16026795 Appendix ACLEAN FILTER QuickStartReferenceGuideRefer to Product Safety Manual for Safety Statements So...how do I use it? Electronic ControlRefer to Product Safety Manual for Safety Statements Quick Start Reference GuideDO NOT power spray No metal pans ?Can I change an option?