Instructions for Installation (cont'd)

Locating The New Water

Heater

You should carefully choose an indoor location for the new water heater, because the placement is a very important con-

sideration for the safety of the occupants in the building and

for the most economical use of the appliance. This water heater is not intended for outdoor installation,

ACAUTION

WATER HEATERSEVENTUALLYLEAK: Installation of the water heater must be accomplished in such a manner

that if the tank or any connections should leak, the flow of water will not cause damage to the structure. Forthis reason, it is not advisable to install the water heater in

an attic or upper floor. When such locations cannot be avoided, a suitable drain pan should be installed under

the water heater. Drainpans are available at your local hardware store. Such a drain pan must have a minimum

diameter of at least 1¾ inches greater than the water heater diameter and must be piped to an adequate

Whether replacing

an old water heater or putting the water

drain. Under no circumstances is the

manufacturer or

heater in a new location,

the following critical points must be

Maytag to be held liable for any water

damage in con-

observed.

 

 

 

nection with this water heater.

 

 

 

 

 

 

1. The location selected

should be indoors

as close to and as

il CAUTION

]

 

 

 

 

 

1

centralized with

the water piping system

as possible. This

INSTALLATION IN RESIDENTIAL GARAGES: The water I

water heater, as well as all water heaters, will eventually leak. Do not install without adequate drainage provisions

where water flow will cause damage.

Typical Installation

CONSULT THE LOCAL UTILITY COMPANY TO EXAM- INE INSTALLATION FOR PROPRIETY AND SAFETY.

* &WARNING

I

HOTTER WATER CAN SCALD: Water heaters are

heatermustbe locatedand/or protectedsoit isnotl

subject to physical damage by a moving vehicle.

J

2.The location selection must provide adequate clearances for servicing and proper operation of the water heater.

VACUUM.EQO,RESODMECODES

(REFERTO LOCALCODES)

SHUTOFFVALVE

f "oO;LW CO,DW,T R,NLE

ELBOW

UNIO

intended to produce hot water. Water heated to a I CHECK ALL CONNECTIONS FOR LEAKS.. temperature which will satisfy clothes washing,

_

N__°t

_, 3/4,,THREADED

anddish permanentlywashing, and injureother sanitiyouzuponing needscontactcan.Somescald I people are more likely to be permanently injured by hot water than others. These include the elderly,

children, the infirm, or physically/mentally handi- capped. If anyone using hot water in your home fits into one of these groups or if there is a local code or

state law requiring a certain temperature water at the hot water tap, then you must take special pre-

cautions. In addition to using the lowest possible

temperature settingthat satisfies your hot water needs, a means such as a mixing valve, should be

used at the hot water taps used by these people or at the water heater. Mixing valves are available at

plumbing supply or hardware stores. Follow manu-

T_REDL___

OUTLET*MIXINGVALVE

/

/

ELECTRICAL D JUNCTIONBOX

_'3_NTH_oRS

"e_TEMPERATURE"

PRESSURE

RELIEFVALVE

--DISCHARGE

PIPE

(Do not cap or plug)

tacturersBefore changinginstructionsthe faforctoryinstallationsetting onofthethethermovalves-. stat, read the "Temperature Regulation" section in

/DRAINVALVE

this manual.

_'-{6- " AIRGAP

_roSUITABLEDRAIN

9

Page 9
Image 9
Maytag HE2940L, HE3940T, HE3940L, HE3950T, HE3940S, HE3966T, HE3950S, HE3930T, HE2950T, HE2940T, HE2930T Locating The New Water