Instructions for Installation (cont’d)
Installation Checklist
1. | Whether or not the element conversion is made, the model |
| rating plate must be marked. Using a hard point ink pen, |
| check the appropriate block within the model rating plate, |
| which is located adjacent to the lower access panel. |
2. | Is the fuse or circuit breaker size correct as shown in the |
HOT
COLD
| chart in the “Product Specifications” section? |
3. | Are the wires from the circuit breaker or fuse service to the |
| water heater’s junction box on the correct wire size (gauge) as |
| shown in the chart in the “Product Specifications” section? |
4. | Is the new |
| installed, and piped to an adequate drain? See |
| |
| for Installation” section. |
5. | Is the water heater completely filled with water? See |
| “Filling the Water Heater” instructions in the “Instructions |
| for Installation” section. |
6. | Will a water leak damage anything? See “Locating the |
| New Water Heater” in the “Instructions for Installation” |
| section. |
7. | Are the cold and hot water lines connected to the water |
| heater correctly? See “Water Piping” instructions in the |
| “Instructions for Installation” section. |
8. | Is there adequate clearance for maintenance around the |
| water heater? |
9. | Do you need to call your electric company to check your |
| wiring? |
HOT COLD
CONDUIT
TEMPERATURE-
PRESSURE
RELIEF VALVE
DISCHARGE PIPE (Do not cap or
plug)
6″ AIR GAP
FLOOR DRAIN
MODEL RATING PLATE
18