Hearth and Home Technologies CNXT4842ILH, CNXT4842IH Install Horizontal Termination Cap, Interior

M. Install Horizontal Termination Cap

WARNING! Risk of Fire! The telescoping flue section of the termination cap MUST be used when connecting vent.

•1-1/2 (38 mm) minimum overlap of flue telescoping section is required.

Failure to maintain overlap may cause overheating and fire.

•Vent termination must not be recessed in the wall. Siding may be brought to the edge of the cap base.

•Flash and seal as appropriate for siding material at outside edges of cap.

•When installing a horizontal termination cap, follow the cap location guidelines as prescribed by current ANSI Z223.1 and CAN/CGA-B149installation codes and refer to Section 6 of this manual.

CAUTION! Risk of Burns! Local codes may require installation of a cap shield to prevent anything or anyone from touching the hot cap.

NOTICE: For certain exposures which require superior resistance to wind-driven rain penetration, a flashing kit and HRC caps are available. When penetrating a brick wall, a brick extension kit is available for framing the brick.

Note: When using termination caps with factory-supplied heat shield attached, no additional wall shield firestop is required on the exterior side of a combustible wall.

Heat Shield or	Heat Shield
Extended	1-1/2 in. (38 mm) min.
Wall Shield Heat Shield	overlap
Firestop
Slip Section
can be extended
Inner Vent	SHEATHING
Outer Vent
INTERIOR	EXTERIOR
Vent depth from back of appliance to
outside surface of exterior wall
(see chart below)
Figure 10.26 Venting through the wall

Cap Specification Chart (depth without using additional pipe sections)

	DVP-TRAPK1	DVP-TRAP1	DVP-TRAPK2	DVP-TRAP2	DVP-TRAPK1	DVP-TRAPK2
	Top Vent Depth	Rear Vent Depth	Top Vent Depth	Rear Vent Depth	Top Vent Depth	Top Vent Depth
	4-1/8 to 6 in.	4-5/8 to 6-1/2 in.	6-1/2 to 10-1/2 in.	7 to 11 in.	1 5/8 to 3 1/2 in.	4 to 8 in.
CNXT Series
	DVP-HPC1	DVP-HPC1	DVP-HPC2	DVP-HPC2
	Top Vent Depth	Rear Vent Depth	Top Vent Depth	Rear Vent Depth
	4-1/8 to 6-1/4 in.	4-5/8 to 6-3/4 in.	6-1/4 to 10-3/8 in.	6-3/4 to 10-7/8 in.

DVP-TRAP1 can adjust 1-7/8 in. (4-3/16 to 6-1/16)

DVP-TRAP2 can adjust 4 in. (6-9/16 to 10-9/16)

SLP-TRAP1 can adjust 1 5/8 in. (3 1/8 to 4 3/4)

SLP-TRAP2 can adjust 4 in. (5 1/4 to 9 1/4))

DVP-HPC1 can adjust 2-1/8 in. (4-1/4 to 6-3/8)

DVP-HPC2 can adjust 4-1/8 in. (6-3/8 to 10-1/2)

50 Heatilator • Caliber CNXT Series • 4047-132 Rev U • 11/08