F. Installing Vertical Termination Baffle

Note: For vertically terminated installations only.

Note: If installing a vertical vent/termination run off the top or rear of the appliance, the vertical termination baffle supplied with the appliance may be used.

Remove the glass (refer to Section 14.H.) to access the firebox and 5 in. inner flue.

Fold the baffle (Figure 7.17) to an approximate 90° angle (see Figure 7.18).

Figure 7.17 Flat Baffle

Figure 7.18 Baffle Bent to 90° Angle

Part of the refractory must be removed before installing the vertical baffle.

-Remove the four screws holding the refractory retainers in place. See Figure 7.19.

Figure 7.19 Remove Refractory Retainers

-Remove the retainers.

-Remove the right or left side refractory (only one side must be removed) by gently raising the front of the top refractory and lifting the side piece up slightly and pulling out. See Figure 7.20.

Push & hold the

front edge up.

Figure 7.20 Remove One Side Refractory

-Remove top by gently lowering toward side just removed and gently twisting out. See Figure 7.21.

Figure 7.21 Remove Top Refractory

32

Heatilator • Caliber CNXT Series • 4047-132 Rev U • 11/08

Page 32
Image 32
Hearth and Home Technologies CNXT4842ILT, CNXT4842IH, CNXT4842ILH Installing Vertical Termination Baffle, Flat Baffle