Wiring the Wall Switch
•Install the provided control wire from the fireplace to the switch location. (Control wire for Heatilator products is supplied with the fireplace).
NOTICE: Do not to stress the wire around tight or sharp corners. Do not run the control wire adjacent to existing or future phone, data, cable, or electrical lines. The wire should not come into contact with any part of the fireplace exterior with the exception of where it exits the outer wrap.
•Feed the wire to the electrical junction box and through a provided or approved strain relief.
•Connect the wires to the terminals as shown in Figure 12.2. Do not
•Using the screws provided, mount the switch to the electrical junction box right side up.
•Install provided cover plate using the screws provided. Do not use a substitute cover even though it may fit. The provided one is specifically designed for the automatic (thermostat) function of the unit.
BLACK
| WHITE |
|
| GREEN | BROWN |
ORANGE |
| |
|
| |
GROUND |
|
|
BLACK |
|
|
IPI |
|
|
VALVE |
|
|
|
| 1 |
| IPI | 2 |
| MODULE | 3 |
| 4 | |
|
| |
|
| 5 |
|
| 6 |
|
| 7 |
|
| 8 |
FLAME | Red (MALE/FEMALE) | 3V DC |
Red (MALE/FEMALE) |
| |
SOLENOID |
|
|
| FLAME ON | RED |
|
| RED |
ADAPTER WIRES | FLAME HIGH/LOW | AC |
| ||
| PLUG | |
|
| |
|
| AUX |
|
| CONNECTION |
BATTERIES
BLACK | RED | YELLOW OR |
|
| WHITE |
BLACK | RED |
|
BROWN | * | |
BROWN |
| |
| RED |
|
BLACK
ORANGE
ORANGE
BLACK
BLACK
RED
REAR VIEW
GREEN
*
FRONT VIEW
YELLOW
YELLOW 
TEMPERATURE 
SENSOR SWITCH
FAN THERMOSTAT
* May be labeled as “W” or “Y”.
Figure 12.2 Intellifire (IPI) Wiring Diagram
GROUND PIGTAIL
GREEN
BLACK
FAN
CONNECTION
54 | Heatilator • Caliber CNXT Series • |
