5.Attach the copper tubing to the refrigerator with a “P” clamp. Slide the plastic water line into the retainer.
A
B
C
A.“P” Clamp | C. Compression sleeve |
B. Brass nut |
|
6.Turn on water supply to refrigerator and check for leaks. Correct any leaks.
Complete the Installation
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death, fire, or electrical shock.
1.Plug into a grounded 3 prong outlet.
2.Flush the water system. See “Water and Ice Dispenser.”
NOTE: Allow 24 hours to produce the first batch of ice. Discard the first three batches of ice produced. Allow 3 days to completely fill the ice container.
Refrigerator Doors and Drawer
All graphics referenced in the following instructions are included later in this section after “Final Steps.”
Remove and Replace Handles
1.Using a ³⁄₃₂" Allen wrench, loosen the two setscrews located on the side of each handle. See Metal Handle graphics 1 and 2.
2.Pull the handle straight out from the door. Make sure you keep the screws for reattaching the handles.
3.To replace the handles, reverse the directions.
Remove Doors and Hinges
IMPORTANT:
■Remove food and any adjustable door or utility bins from doors.
■Keep the refrigerator doors closed until you are ready to lift them free from the cabinet.
NOTE: Provide additional support for the refrigerator door while the hinges are being removed. Do not depend on the door gasket magnets to hold the door in place while you are working.
TOOLS NEEDED: ⁵⁄₁₆", ³⁄₈", ¹⁄₄"
1.Unplug refrigerator or disconnect power.
2.Remove the base grille. Grasp the grille firmly and pull it toward you.
3.Starting with the
4.Remove the hinge pin cover from the bottom hinge pin and keep it for later use. See Bottom Hinge graphic.
5.Remove top hinge cover from left side refrigerator door.
6.Remove the façade from the front of the top of the cabinet. Remove the screw on the backside of the center of the façade, then slide the façade forward and out from under the hinge.
7.Disconnect the wiring plug located on top of the hinge by wedging a
8.Disconnect the water line by pulling back on the locking collar while pulling the water line out of the water line connector.
9.Remove the parts for the top hinge as shown in Top Hinge graphic. Lift the
NOTE: On some models, remove the hinge pin cover from the bottom hinge pin and keep it for later use. See Bottom Hinge graphic.
10.Using a ³⁄₈" hex wrench, remove the leveling leg brackets from the bottom of the cabinet. Keep screws for later use.
5
