11
5. Next, place the level on the side of the washer in the crease between the top of the
washer and the cabinet.
Level the side.
6. If the washer is not level, move the washer out slightly, tip back, prop up the front of the
washer on a wood block. Adjust the feet up or down as necessary by twisting the feet.
Repeat steps 1 through 5 until washer is level.
7. Use a 916" or 14 mm open-end wrench to turn the locknut counterclockwise on the foot
tightly against the washer cabinet.
IMPORTANT: If the locknut is not tight against the washer cabinet, the washer may
vibrate.

Complete Installation

1. Check the electrical requirements. Be sure that you have the correct electrical supply and
the recommended grounding method. See “Electrical Requirements.
2. Check that all parts are now installed. If there is an extra part, go back through the steps
to see which step was skipped.
3. Check that you have all of your tools.
4. Keep the foam packing ring from the washer tub for future relocation of the washer.
Dispose of/recycle all packaging materials.
5. Check that the water faucets are on.
6. Check for leaks around faucets and inlet hoses.
7. Plug into a grounded 3 prong outlet.
8. Remove any protective lm or tape remaining on the washer.
9. Read “Washer Use.
10. To test and to clean your washer, measure 12 of the detergent manufacturer’s
recommended amount of High Efciency (HE) powdered or liquid detergent for a medium-
size load and pour it into the detergent dispenser. Close the lid. Press
POWER/CANCEL. Select a normal cycle and press START/PAUSE. Allow it to complete
one whole cycle.

BENEFITS AND FEATURES

Your washer has several benets and features which are summarized here. Some items may
not apply to your model.

Benets

High-Efciency Wash System

Your new top loading, high-efciency washer saves you time by allowing you to do fewer,
larger loads. It also conserves resources and lowers your water and energy bills by using the
following innovations.

INTELLIFILL™ Water Level Control

This washer senses the load size and composition through a series of lls and wash motion.
It then adjusts the water level for the best cleaning and rinsing performance. It eliminates the
guesswork. The water level is just right for every wash load size.
NOTE: You may notice during a cycle that the wash load is not completely submerged in
water. This is normal for your washer.