Maytag W105623338C-SP Low or no line voltage, Replace the fuse or reset the circuit breaker

TROUBLESHOOTING

First try the solutions suggested here or visit our website at www.maytag.com/product_help –

In Canada www.maytag.ca for assistance and to possibly avoid a service call.

If you experience	Possible Causes	Solution
Dryer Results (cont.)

Load too hot

Load removed before cool down	Allow the dryer to complete the cool down portion of the cycle
portion of cycle complete.	before removing the load.
Using Timed Dry Cycle with a high	Select a Sensor cycle with a lower heat setting to avoid overdrying
temperature setting.	the load.

Dryer Displaying Code Message or Indicator Is Lit

“PF” (power failure)	The drying cycle has been interrupted	Press and hold START/PAUSE to resume the cycle, or press
	by a power failure.	POWER to select a new cycle.
“L2” Diagnostic Code	There may be a problem with your	The dryer will continue to run when this diagnostic code is present.
(low or no line voltage	home power supply keeping the dryer’s	Press any key to clear the code from the display and return to the
condition)	heater from turning on.	estimated time remaining.
		Try the following:
		• Check to see if a household fuse has blown or circuit breaker
		has tripped. Electric dryers use two household fuses or breakers.
		Replace the fuse or reset the circuit breaker.
		• Confirm the power cord is properly installed. Refer to Installation
		Instructions for details.
		Select a Timed Dry heated cycle, and restart the dryer.
		If the message persists, consult a qualified electrician.
Check Vent indicator is lit	The lint screen or vent is clogged; the	The dryer will continue to run when this diagnostic code is present.
	vent is crushed, kinked or has too many	Touch any key to clear the code from the display and return to the
	turns.	estimated time remaining.
		Try the following:
		• Clean lint screen.
		• Check to see if the vent run from the dryer to the wall is
		crushed or kinked.
		• Confirm that the vent run from the dryer to the wall is free
		of lint and debris.
		• Confirm that the exterior vent exhaust hood is free of lint
		and debris.
		• Confirm that your vent system falls within the recommended
		run length and number of elbows for the type of vent you are using.
		Refer to “Plan Vent System” in the Installaton Instructions for
		details.
		Select a Timed Dry heated cycle, and restart the dryer.
		If the message persists, have your entire home venting run cleaned.
		Contact a venting specialist.
“F# E#” (F1 E1, F3 E1,	The dryer is in need of service.	If a code beginning with an “F” appears in the display, alternating
etc.) variable service		between F# and E#, the dryer control has detected a problem that
codes		requires service. Call for service.

16