How to Operate the MCD301, con’t
WMA encoded discs. MP3/WMA allow more tracks on the Disc by using the technique of lossy compression ap- plied to the original audio information. The MP3/WMA Track has lower audio quality
than the original recording. Load a MP3/WMA disc into the MCD301. Refer to figure 26.
1.Press the PLAY
Notes: 1. The MCD301 |
|
| |
will indicate | 0 4 Fd 3 6 Tr | ||
either elapsed | |||
|
| ||
time or remain- |
|
| |
Figure 27 |
| ||
ing time for each |
|
| |
track when play- |
|
| |
ing MP3/WMA | 0 2 Fd 2 6 Tr | ||
Discs. | |||
2. When play- |
|
| |
Figure 28 |
| ||
ing MP3/WMA |
| ||
|
| ||
Discs, the left side of the Front Panel Informa- | |||
tion Display indicates the total number of fold- | |||
ers on the disc followed by the Track Number | |||
or the Track |
|
| |
|
| ||
Time. | S I N G . | E . | |
Display Modes | |||
|
| ||
Figure 29 |
| ||
The MCD301 Front Panel |
| ||
|
| ||
Information Display allows for |
|
| |
either Track or Time indica- | 0 2 : 3 6 | ||
tions. To change from the | |||
|
| ||
default setting of Track indica- |
|
| |
Figure 30 |
| ||
tion to Time, press the TIME |
|
| |
|
| ||
or the DISP/TIME | S I N G . | R . | |
on the Remote Control. Refer |
|
| |
to figure 6 on page 16 and | Figure 31 |
| |
figure 16. |
|
| |
|
| ||
The Time Display Choices | |||
are Single Track Elapse Time | |||
(figures 29 and 30), Single |
|
| |
Figure 32 |
| ||
Track Remaining Time (fig- |
| ||
|
| ||
ures 31 and 32) or Total Tracks |
|
| |
Remaining Time (figures 33 | T O T A L | R . | |
and 34). | |||
|
| ||
|
|
| |
| Figure 33 |
|
-5 6 : 1 8
Figure 34
Display Brightness
The MCD301 Front Panel Information Display has two brightness settings. To change from the default setting (brightest of the two) perform the following:
1.If the MCD301 is playing a disc press the STOP
2.Press and hold the
Note: Depending on the brightness setting before press- ing the
Resetting the MCD301
In the unlikely event the MCD301 stops functioning, the microprocessors can be reset by performing the following:
1.Press and hold in the STOP
indicate “INITIAL”, release your finger from STOP
2. Press and hold in the STANDBY/ON
3. When the STANDBY/ON LED is no longer illuminated, release the STANDBY/ON
4. When the STANDBY/ON LED is illuminated press the STANDBY/ ON
Note: This can be performed with the MCD301 On or in the Standby Mode.
Figure 16
19