TEMPERATURE AND HUMIDITY MODE

The weather station supports up to 3 remote thermo-hygrometers corresponding to a separate channel of the temperature and relative humidity display. The temperature can be displayed in Celsius (ºC) or Fahrenheit (ºF).

The main unit carries the temperature and humidity sensor and uses this indoors data to calculate an indoors comfort level - Wet, Comfort or Dry.

A temperature alert function is available for each channel. It can be programmed to sound if the channel temperature exceeds or falls below the pre-set upper and lower limit.

Note: The temperature alerts have a 0.5 ºC deviation to prevent them from sounding due to small temperature fluctuations that are close to the set alert value. This means that after the temperature reaches the alert temperature, it will have to fall below the alert temperature plus the deviation (0.5°C) to activate the alert.

Accessing Temperature and Humidity Mode

From the main unit: Press UP ? or DOWN ? until the IN icon on the upper right will flash.

Viewing Temperature and Humidity for each Channel

Static Display:

In Temperature and Humidity Mode, press the CHANNEL button to recall a different channel. Channel Auto-Scan Display:

To enable automatic scan of the different channels, press and hold CHANNEL, until the icon is displayed. Each valid channel will be alternately displayed with a 5 seconds delay.

Recalling of Temperature and Dew Point Displays

In Temperature and Humidity Mode press the SET button to recall temperature and relative humidity or dew point and relative humidity.

Set the Temperature in Celsius or Fahrenheit. (Does not affect Wind Chill)

In Temperature and Humidity Mode, press and hold SET to toggle the temperature in Celsius (ºC) or Fahrenheit (ºF).

Activating/Deactivating the Temperature Alerts

In Temperature and Humidity Mode, press the ALARM/CHART to recall a current temperature for the corresponding channel, the upper temperature alert with ? icon (if disabled, displays OFF), or lower temperature alert with ? icon (if disabled, displays OFF).

Once the above alerts are displayed, press the UP ? or DOWN ? to enable or disable the corresponding alert.

Programming the Temperature Alerts

In the Temperature and Humidity Mode, press ALARM/CHART selecting the desired alarm.

Press and hold ALARM/CHART button until the remote temperature and ? or ? icon starts flashing.

Adjust the temperature digits for the Temperature Alert using the UP ? or DOWN ? . Press and hold either button for fast digits advance.

Press the ALARM/CHART to confirm selection and return to the temperature alert selection screen.

Disabling Temperature Alarm(s)

In the Temperature & Humidity Mode press the ALARM/CHART to disable the alarm(s).

Viewing the Max/Min Channel Temperature and Humidity

In the Temperature & Humidity Mode press the MEMORY button to recall a current temperature and humidity, minimum temperature and humidity or maximum temperature and humidity at the remote location.

Resetting the Remote Temperature and Humidity Memory

In the Temperature and Humidity Mode, press and hold MEMORY button to clear memory for all channels.

Remote Sensor Status

The wave icon above the current channel display shows the connection status of the corresponding remote sensor:

Icon

Status

Searching for remote sensor signals

Corresponding remote sensor successfully linked

No signals received for more than 15 minutes

17

Page 17
Image 17
Meade TE827W user manual Temperature and Humidity Mode