Meco 2420, 2400, 2440, 2430, 2410 owner manual Knob. See

STEP 2) Lift grill up at one leg mount. Release the

spring lever at each leg foot. (FIG. 2A) Swing each

leg all the way out one at a time, and let it rest on

the floor. (FIG. 2B, 2C & 2D) The last leg will allow

the grill to stand by itself. This is the lower height

for use.

Leg Pinch area

FIG. 3B

1 1’4”

FIG. 3D

FIG. 3C

Depress Leg Button

Spring Lever

STEP 4) If the grill is not standing level, the legs

can be adjusted to level it. There are 3 adjustments

FIG. 2A

within a range of 1 1/4” from the fully extended leg

in which to level the grill.

While supporting the grill, depress the round leg

button with your thumb on the leg or legs that need

to be adjusted. (FIG. 3C & 3D) Slide the leg in or

out until you find the setting that best allows level-

ing. You will hear a light click at each setting when

extending the leg. Check the grill level by the level

indicator located to the left of the Main Grill control

FIG. 2C

knob. (See FIG. 1 page 5)

FIG. 2B

STEP 5) Unlatch the hood and remove the Grid.

Disconnect the Electrode wire underneath the bowl.

(FIG. 4A) At a point directly opposite the control

knob, lift up the Bowl Pan and burner and remove

from the grill. (FIG. 4B) Remove the styrofoam pads

inside the bowl area and any that fall toward the

middle. Remove any other accessories that may be

packed inside. Reinstall the Bowl Pan. Insert the

burner tube and electrode wire through the hole in

FIG. 2D

body. The burner guide should engage the burner

tube over the valve nozzle. Check visually to make

STEP 3) To use the grill

sure it does engage. Reconnect the electrode wire.

at the full height, slide

Replace the Cooking Grid. (See page 16)

the legs out one at a

Ignitor

time until they stop. You

Burner tube engaged

do not have to use the

over valve nozzle

leg adjustment for full

leg extension. (FIG. 3A,

3B & 3C)

Burner guide

Fig. 3A

6FIG. 4A Disconnect Electrode Wire from Ignitor