Connecting/Disconnecting LP Gas Cylinders
INSTALLATION CODES
HOSES AND REGULATOR
To reduce the risk of serious bodily injury or death:
·This installation must conform with local codes or, in the absence of local codes, with either the National Fuel Gas Code, ANSI Z223.1, or
·If an external electrical source is utilized, the outdoor cooking appliance, when installed, must be electrically grounded in accordance with local codes or, in the absence of local codes, with the National Electrical Codes, ANSI/NFPA 70, or the Canadian Electrical Code.
LP CYLINDER
To reduce the risk of serious bodily injury or death:
· Use only 1 pound LP cylinders with this grill and the |
appliances. |
· Read and follow all warnings on LP gas cylinder. |
· If you see, smell, or hear the hiss of LP gas escaping |
from the cylinder: |
1. Do not attempt to light appliance. |
2. Extinguish any open flame. |
3. Disconnect from fuel supply. |
· Do not operate the LP gas grill without the LP gas |
cylinder attached or secured to the grill as shown in |
Assembly Instructions. |
· Maintain cylinder in upright position to provide for |
proper fuel withdrawal. |
· Do not use an LP gas cylinder if it shows signs of |
dents, gouges, bulges, fire damage, corrosion, |
leakage, excessive rust or other forms of visual |
external damage; it could be hazardous and should be |
To reduce the risk of serious bodily injury or death:
·Use only the hose and regulator assembly that have been supplied with this gas grill. Do not use hose and regulator from another manufacturer.
·Always check for gas leaks when you connect and disconnect the LP gas cylinder.
·Make sure there are no sharp bends in the hose.
·Make sure gas hoses do not contact hot surfaces.
·Clean and inspect the gas hose/regulator before each use. Replace the hose/regulator before using grill if there is evidence of abrasion, wear, cuts or leaks.
·If the hose and regulator assembly is not working properly and you need a replacement, contact the manufacturer
To reduce the risk of serious bodily injury or death:
·Always inspect LP cylinder connections for damage or debris before connecting cylinders.
·Always connect or disconnect propane cylinders out doors away from flame, ignition sources and only when the appliance is cool to the touch.
STEP 1) Turn control knobs of Main grill, Side Burner and Lantern to the “Off” position.
(FIG. 9A, 9B & 9C)
Main Grill | FIG. 9A |
Control Knob ‘Off’ |
checked by a liquid propane supplier. |
· Never connect or disconnect LP cylinder or fittings |
near open flame or while grill or accessories are |
burning. |
· When the LP gas cylinder is connected, keep the grill |
outside in a |
· Turn off all control knobs to grill, side burner and |
lantern when grill is not in use. |
Side Burner
Control Knob ‘Off’
FIG. 9B
Lantern
Control Knob ‘Off’
FIG. 9C
· Do not attempt to refill or repair a 1 pound disposable |
LP cylinder. It could cause a hazard or explosion. |
1 pound Disposable LP Cylinders, for use with Aussie LP gas grills, must meet the following requirements:
1)Only use cylinders marked “Propane Fuel”
2)1 pound Cylinder size should be 4” diameter x 8” tall.
3)Cylinder must be constructed and marked in accordance with the U.S. Department of Transportation (DOT) or the National Standard of Canada,
4)Cylinder must have a cylinder cap to protect LP cylinder valve when not in use.
STEP 2) Connecting a 1 pound disposable cylinder to Lantern, Main grill Burner and Side Burner is very similar. First remove protective cap from Cylinder nozzle. (FIG. 10A)
Cylinder
protective cap
FIG. 10A
10
