3Com RMON-EMP-3 installation and operation guide 1. Quick Installation Steps

Quick Installation

Table 2-1 outlines the steps necessary to complete the installation of the RMON MultiProbe Module. If you are familiar with installing 3Com modules, use this table as a checklist. Otherwise, consult the remainder of this chapter.

Table 2-1. Quick Installation Steps

Step	Procedure	Chapter/Section
1	Unpack the module.	Chapter 2, Unpacking
		Procedures section
2	Install the module into an open slot in	Chapter 2, Installing
	the hub.	the Module section
3	Connect a terminal or management	Chapter 2,
	workstation to the RS-232 console port	Connecting a Terminal
	on the module faceplate.	section
4	Assign an IP address and subnet mask	Chapter 3, Assigning
	for each RMON interface using a	the Interface IP
	BOOTP server or the configuration	Address and Subnet
	menus.	Mask section
5	Assign a default gateway for the	Chapter 3, Assigning
	module using the configuration menus	the Module Default
	or BOOTP.	Gateway section
6	Configure the RMON interfaces to a	Chapter 3, Assigning
	network using either the DIP switch or	Interfaces to Networks
	the SET PORT command.	section.
7	Configure optional module	Chapter3,Configuring
	parameters using the configuration	the Module
	menus.

Installing the Module 2 - 3