3Com RMON-EMP-3 Modem Init Strings and Hangup Strings, Command Result

Modem Init Strings and Hangup Strings

This section describes the format of the modem:

❑Init Strings

❑Hangup Strings

To allow the RMON MultiProbe Module to communicate with a modem or a serial data switch, use the modem Init String and Hangup String. The strings contain embedded commands to control how the module interacts with a remote device through the serial interface. Commands are represented as 2-character sequences beginning with the ^ character.

Table 3-5 describes the modem Init Strings and Hangup Strings that the RMON MultiProbe Module supports.

Note: Command characters are case-sensitive.

Table 3-5. Modem Init Strings and Hangup Strings

Command	Result
^s	Sends string that follows, which is terminated by the
	next command or the end of string.
^c	Delays for the number of seconds that follows. Discard
	any data received instead of storing it in a buffer for
	parsing.
^t	Sets timeout to the value represented by the decimal
	digits that follow. Thedefault timeout is 20 seconds. The
	timeout may be overridden by a smaller serial Timeout
	configured for the associated serial interface.

Configuring the Module 3 - 17