Assigning Interfaces to Networks
To assign RMON MultiProbe Module interfaces to networks, you can use either:
❑DIP switch settings, if your hub is unmanaged (an ONline or ONcore management module is not installed in the hub).
❑ONline or ONcore network management commands (if an ONline or ONcore management module is installed in the hub).
You can assign the three RMON MultiProbe Module network interfaces as follows:
❑Interface 1 to Ethernet 1 or Isolated
❑Interface 2 to Ethernet 2 or Isolated
❑Interface 3 to Ethernet 3 or Isolated
Note: Each interface can only be configured to its corresponding Ethernet network or isolated (that is, Interface 1 to Ethernet 1, Interface 2 to Ethernet 2, Interface 3 to Ethernet 3).
3 - 32 Ethernet RMON MultiProbe Module Installation and Operation Guide
