3Com RMON-EMP-3 installation and operation guide Using the Rmon MultiProbe Module Slip Address

Using the RMON MultiProbe Module SLIP Address

To communicate with the RMON MultiProbe Module, the client software must use the RMON MultiProbe Module local SLIP address as the module destination IP address. For information on configuring a SLIP route to a device, refer to the workstation UNIX® manual.

Over a SLIP connection, the RMON MultiProbe Module supports the following configuration:

❑Various baud rates (refer to the Serial Configuration menu in Chapter 3, Configuring the Module).

❑8-bit

❑No parity

❑1 stop bit

Specifications A - 9