3Com RMON-EMP-3 installation and operation guide Connecting a Terminal

Connecting a Terminal

You can connect a terminal or workstation running a terminal emulation program to the RMON MultiProbe Module RS-232 port to:

❑Configure IP address information for the RMON MultiProbe Module interfaces

❑Display the RMON MultiProbe Module configuration

To connect a terminal to the RMON MultiProbe Module:

1.Verify that the terminal is configured as follows:

❑8-bit data

❑No parity

❑1 stop bit

❑9600 baud rate

Note: The RMON MultiProbe Module does not support XON and XOFF.

2.Using an RS-232 null-modem cable, attach a terminal (or a workstation running ASCII terminal emulation software) to the RMON MultiProbe Module RS-232 port.

Installing the Module 2 - 7