Connecting Motion / Alarm Device - Appendix #6
Connecting Motion / Alarm Device - Appendix #6
Motion detection and Alarm controls are enabled through the Menu system on the Observation System. Additional motion sensor devices can be connected to the system (Motion Sensors, Door/Window Sensors).
A motion detection or sensor unit can | OBSERVATION SYSTEM |
be used to send a signal to the |
|
Observation System to begin camera |
|
viewing on the matching Video |
|
Channel (when enabled in the |
|
MENU/ALARM SET MODE) |
|
• Example: A Window sensor unit |
|
has been installed on Alarm |
|
Block port #4. When this sensor |
|
is activated, the camera on DIN |
|
or BNC VIDEO port #4 will |
|
become active (if enabled in the |
|
MENU on the Observation |
|
System) |
|
For the corresponding Menu Pro- |
|
gramming, refer to Page 26. |
|
Installing a Sensor
1.Connect the GROUND Cable to the GND port on the Alarm Block on the Observation System
21
2.Connect the SIGNAL Cable to a numbered port
To start ALARM RECORDING on a DVR unit, refer to the manual for your specific DVR product.
SENSOR
(Not Included)
45
