Motion Set, Motion SET | LOREX Technology SG17L7584 specification

Motion Set

Motion Set

This submenu allows you to change the configurations for MOTION detection, using the monitors built-in Pixel Based Motion Detection.

1.MOTION - Sets the motion detection alarm mode. Navigate by pressing the K and L buttons to highlight, and press the OK button to switch between MOTION alarm modes:

•OFF - Motion Detection is disabled

•OSD (On Screen Display) - Visual alert only [MD]

•OSD + BUZZER - Both Visual and Audible alerts

2.CHANNEL - Configure the MOTION detect

settings for channel sets CH1/5, CH2/6, CH3/7 and CH4/8. Navigate by pressing the K and L buttons to highlight, and press the OK button to select the channel to change. Once a channel has been selected the SENSITIVITY and AREA can be configured.

3.SENSITIVITY - Configure the sensitivity of the MOTION detect. Navigate by pressing the K and L buttons to highlight, and press the OK button to set the SENSITIVITY mode from [00] to [05] (where 05 is the most sensitive setting). Press OK to accept the selection.

[MOTION SET]

MOTION	:	[OFF]
CHANNEL	:	[CH1/5]
SENSITIVITY	:	[02]
AREA	:	[00]
RETURN	:	[ ]
EXIT	:	[ ]

27

Image 27

LOREX Technology SG17L7584 instruction manual Motion Set, Motion SET

Contents

Color LCD Dual Quad Security Surveillance System Page Installation Important Safeguards Service Lorex Technology INC General Precautions Observation System Features Standard Camera FeaturesNetViewer Software Table of Contents Camera Remote ControlGetting Started Cameras with 15 16 17 18 19 20 21 SG17L7584 Front Primary Function Buttons UP / Down / Right SG17L7584 Front Primary Function Buttons Dual PIP POP Mode 10 11 12 13Listen in Audio only SG17L7584 Front Secondary Function Buttons MIC Enable TWO-WAY Audio with select Lorex cameras Slave Monitor SG17L7584 Back SG17L7584 Back Remote Control Input Cable Back Installing CamerasCamera Lens Microphone Observation System Connecting CamerasPower To Connect the Cameras to the Moni- tor Monitor Features ThumbscrewsMonitor Tilting Point Cable Channel Main Menu Control Time / Date Set Disp MON Display the Date / Time onTIME/DATE SET Sequence SET Sequence Set PIP/POP SET PIP/POP Set Title SET Title Set Alarm SET Alarm Set Motion SET Motion Set Full Screen System Set Loss Buzzer Sets the audible Buzzer onSystem SET System SET Monitor SET Monitor Set NetViewer Installation Requirements Network Connectivity Observation System Internet RouterNot Included Navigate to http//DDNS.strategicvista.net Setting Up Your Ddns Account Dns1.strategicvista.net Finding Your External IP Address Using the Lorex IPEdit Application Internal Network Router Port ForwardingNetwork Example Internet Router Computer Troubleshooting ProblemCheck Image on the Observation System is too dark or too bright TFT LCD Observation System Specifications Appendix #1 Camera Specifications Appendix #2 DVR Note VCR NoteObservation System Single Channel DVR or VCR Connecting to a Multi-Channel DVR Appendix #4 RCA to BNC AdaptorDVR Unit Connecting a Slave Monitor Appendix #5 Sensor Connecting Motion / Alarm Device Appendix #6 1/4 CCD Cameras Included Full Connectivity Diagram Appendix #7 Cameras Optional AccessoriesCable DVR Unit Camera Optional Accessories It’s all on the web