Network Connectivity
Network Connectivity
The SG17L7584 Observation System can be remotely controlled using your existing network and the provided NetViewer software.
1.Connect the Observation System to the Router using the supplied Ethernet Cable. Power the Observation unit on. You may need to tilt the monitor forward to access the Ethernet Port.
NOTE: The Observation System must be connected to the router prior to powering on the system. This allows the system to communicate on your network
2.Set up a web account at http:// DDNS.strategicvista.net. Refer to Pages 35 - 36 for setup and configuration instructions.
3.Install the NetViewer software on your PC. See Page 33 for installation requirements, and refer to the provided ‘NetViewer Guide’ with your product for details on using the software.
4.Find the IP address of your Observation using the Lorex IPEdit application. See Page 37 for details
5.Enable PORT FORWARDING on your Router. Refer to the instructions on Page 38 for details.
OBSERVATION SYSTEM
INTERNET
ROUTER
(Not Included)
PC
(Not Included)
33
