
The Main configuration menu appears (Figure 2-2).
Main menu Rev x.xx (Rev x.x)
1Modify/View configuration values
2Download new firmware
3Warm start and Exit
4Cold start and Exit
Enter one of: 1 2 3 4 ?
Figure 2-2. Main Configuration Menu
5.Refer to Chapter 3, Configuring the Module, for a description of the configuration menus and instructions for configuring the module and its interfaces using the configuration menus.
Once you configure the RMON MultiProbe Module and it initializes successfully, the module begins to operate normally and monitor the network.
Note: Hardware flow control is not active on the RMON MultiProbe Module when you are using the configuration menus. Depending on the Serial Port Mode setting, hardware flow control is active when you exit the configuration menus.
For information on the Serial Port Mode settings, refer to Chapter 3, Configuring the Module, Table
Installing the Module 2 - 9