LIGHTING THE GAS GRILL
To reduce the risk of serious bodily injury or death:
·Use only 1 pound LP cylinder with this Grill.
·Open Hood before lighting the grill to prevent an explosion from gas
·Make sure there are no obstructions to the flow of combustion and ventilation air to the main grill.
·During failed lighting attempts, or if the side burner goes out during the cooking process, turn control knob “Off” to dissipate any accumulation of gas. Wait five minutes before repeating lighting procedure.
·To avoid burns, keep hands and fingers away from the burner ring when manually lighting with a match.
IGNITION LIGHTING MAIN GRILL |
| MANUAL LIGHTING MAIN GRILL |
1.Open the Hood. Make sure LP cylinders are installed.
2.Important: Make sure main grill control knob is turned “Off” first.
3.Push the control knob in and turn to the “High” position. (FIG. 13A)
4.Push the Ignitor button in several times to light the burner. Listen for the spark ignition and look to make sure the burner is lit. If no spark, see (FIG. 13B) and Troubleshooting Section.
5.If Grill burner fails to light, repeat Steps
If the burner fails to light after three or four attempts following Steps
6.After ignition, turn the control knob to “High” for
If the burner goes out during operation, turn the control knob to the “Off” position. Open hood and wait five minutes before attempting to relight the grill. If it does not relight, turn control knob to the “Off” position. Make sure there are no open flames nearby, then disconnect the cylinder and see if it is empty.
Push in Control Knob and turn to “High”.
Ignitor Button
FIG. 13A
Electrode
Gas Collector Box
FIG. 13B
1.Open the Hood. Lift the Cooking Grid off the Grill.
2.Important: Make sure main grill control knob is turned “Off” first.
3.Hold a lit match near the burner ring. (FIG. 13C)
4.Push the control knob in and turn to the “High” position. (FIG. 13A)
5.If Grill burner fails to light, repeat Steps
If the burner fails to light after three or four attempts following Steps
6.After ignition, replace the Cooking Grid. Turn the control knob to “High” for
If the burner goes out during operation, turn the control knob to the “Off” position. Open hood and wait five minutes before attempting to relight the grill. If it does not relight, turn control knob to the “Off” position. Make sure there are no open flames nearby, then disconnect the cylinder and see if it is empty.
|
|
|
|
|
|
|
| Hold lit match |
|
|
|
| near burner ring. |
|
| FIG. 13C | |||
|
|
|
|
|
|
|
|
|
|
3/16” Gap from Tab to Electrode
13
