INSTALLING THE UNIT UNDER A CABINET
The suggested mounting position of the unit is under a wall cabinet, but it can be installed under many areas. There should be at least
IMPORTANT NOTES: | • | Install the unit as far as possible from a source of noise; i.e., | |||
• Since the unit is rather heavy, be careful while mounting. |
| a refrigerator, microwave oven, fluorescent lamp, etc. | |||
• To reduce risk of fire, do not place any heating or cooking | • Please allow ample space on each side for the speakers. | ||||
appliance beneath the unit, especially while the LCD screen | • | Keep unit away when drilling to avoid getting wood | |||
is open. | • | shavings in the ventilation holes. | |||
• Mount the unit so that its AC adapter can be plugged directly | Drill from bottom up if there is not enough room in the | ||||
to a wall outlet. |
| cabinet. | |||
• Do not use a converter or extension cord. |
|
|
| ||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Cut the template and place inside the cabinet with the template border marked “FRONT” along the front edge of the cabinet, then use adhesive tape to fix the template. Drill four 1/4” diameter holes as shown on the template. Remove template when finished.
Measure the height of the cabinet bottom and overhang.
If the cabinet bottom is 1” thick, then the spacers are not necessary, use screws only as shown.
If the cabinet bottom is 3/4” thick, then use the spacers turned upwards as shown.
If the cabinet bottom is 3/8” to 1/2” thick, then use the spacers turned downwards as shown.
With a screwdriver (not an electric screwdriver or drill), fasten the four screws into the spacer holder holes (or fasten the screw to your set if spacers were not needed). Start screwing at two opposite corners of the unit for better support.
6
Push the release latch, pull down the screen to a maximum of 180° and rotate.
