2. LED Power and Activity Monitor
When the green LED is lighted, the TravelDrive™ is powered and recognized by your computer. When the LED is flashing, that means that data are being transferred to or from your drive. Always wait until the LED stops flashing before removing the TravelDrive™! Removing the drive while the LED is flashing risks corrupting the data files and losing access to any other files on the drive.
3. Lanyard Carrying Strap
To attach your Lanyard to your TravelDrive™, remove the portion with the small thin nylon strap by depressing each side of the connector. Once you have removed this connector, slide the small nylon loop thru the cap keyhole and insert the connector end thru the middle of the nylon loop. Reattach the connector to the main strap line of the Lanyard.
IXTroubleshooting:.
1.The green Power and Activity LED does not light.
This means the TravelDrive™ is not receiving power from the USB port. Check to see if the computer recognizes the device as attached and active. In Windows®,
2.The TravelDrive™ appears to be full, but I can't find any files on it.
The files may have been corrupted if data were interrupted during a transfer, either by too early a removal or by a power interruption. Restart your computer and attempt to access your drive. Otherwise, you may need to attempt using some recovery software to possibly rescue some files on your TravelDrive™. At this time, Memorex does not have any specific software that it can endorse or support to perform this operation. If this operation is not required or the files on your drive are not needed, you will have to reformat your TravelDrive™ to regain its functionality.
IMPORTANT NOTE: Reformatting permanently erases all the data on the TravelDrive™, and you will lose any unsaved files. See "XI. Reformatting" below.
