15.Install new thermostat with two screws and replace knob.
16.Position the balance of tube so it runs from bottom of thermostat along inside of front panel. Coil excess parallel to and under shelf. Make certain tube is away from all electrical connections.
17.Check tube positioning before replacing panel to be sure the tube will clear all electrical connections.
18.Replace heater element, wire guard, insulation, heater wires, (refer to wiring diagram) and side panels.
Figure 5
D Heater Unit Assembly Re- placement:
(Refer to Figure #5)
1.Remove right panel.
2.Holding the heater connections with pliers to prevent bending, remove the three screws retaining the wiring harness on the heater connections of the unit being replaced. (Figure #4)
3.Remove insulation.
4.Remove the two screws holding heater element to inside panel.
5.Slide heater unit out the side.
NOTE: Because of air space required in some heating elements they may not easily pass thru the opening. If element does not slide out completely, remove left side panel, insulation and wire guard. (Refer to Section O). Use a suitable “flat” tool such as a yardstick or 24” ruler and insert through wire guard opening. Gently pry heating element at curvature so it can clear opening and slide out. (Figure #6)
Figure 6
3
