6.Slide new heater unit into place and fasten with two screws.
7.Replace insulation.
8.Reconnect wiring harness (Refer to Wiring Diagram). Hold heater terminals with pliers. Be sure all connections are tight and jumper has been installed between upper heater unit connections.
EIndividual Heater Element Replacement:
Each heater unit is equipped with two elements.
These may be replaced individually as follows:
1.Remove heater unit as described in Section D.
2.Place unit on a flat surface and remove jumper and the two screws, nuts and retainers.
3.Bend holding tabs away from element and lift out at an angle that will let terminal ends clear holes.
4.When replacing elements, make certain that element with “raised bend” is on top and “flat” on bottom. There should be air space at points circled in (Figure #7). Elements must not touch at these points.
7
208V-21107
F Motor Replacement:
(Refer to Figure 8, 9 & 9A)
1.Remove right side panel.
2.Disconnect motor lead wire from terminal block and conveyor speed control (and or P.C. board if your unit contains one). Or
3.Remove two mounting bolts from under toaster that attach motor bracket. Slip off drive chain.
4.Lift out motor and bracket assembly and remove four screws holding motor to bracket.
5.Using 1/16” Allen wrench, loosen Allen screws and remove clutch sprocket from motor shaft.
6.Mount clutch sprocket on new motor shaft and mount new motor on bracket.
7.Install motor and bracket assembly attaching with the two mounting bolts. Do not tighten bolts.
8.Mount drive chain on sprocket by sliding motor to the left then adjust chain by sliding motor to the right (Figure #8). Tighten bolts.
4
