9.Check sprocket alignment (Figure #9) and adjust if necessary by moving clutch sprocket on motor shaft. See Section G, Number 5.
10.Reconnect wires (Refer to Wiring Diagram) and replace side panel.
G Drive Chain Replacement:
(Refer to Figure 8 & 9)
1.Remove right side panel.
2.Loosen motor mounting bolts and slide motor to left to loosen chain.
3.Lift off old chain and position new chain over sprockets. Check orientation. (Figure #9).
4.Slide motor to right to remove chain slack and tighten motor mounting bolts.
5.Check chain tension. (Figure #8). Too tight will result in premature wear of chain, sprocket and bearing and may bind drive components. Too loose will result in chain slipping or falling off sprockets.
HClutch Sprocket Replace- ment:
(Refer to Figure 8)
1.Remove right side panel.
2.Loosen motor mounting bolts and slide motor to left and remove drive chain.
3.Loosen Allen screws on clutch sprocket and remove sprocket from motor shaft.
4.Install new sprocket on motor shaft and tighten screws. Check sprocket alignment (Figure #9).
5.Position chain on sprocket and slide motor to right to remove slack. Tighten mounting bolts. Check chain orientation.
6.Check chain tension (Figure #8) and adjust if necessary. See Section G Number 5.
7.Replace right side panel.
I Hubbed Sprocket Replacement:
(Refer to Figure 10)
1.Remove right side panel.
2.Loosen motor mounting bolts and slide motor to left.
3.Remove drive chain and loosen Allen screws on hub of sprocket and slide off shaft.
4.Install new sprocket and align set screws with indents in transmission shaft.
5.Replace drive chain and slide motor to right to tighten (Figure #8) see Section G Number 5.
6.Replace right side panel.
J Bearing Replacement:
Coupling Bearing (Right Side)
1.See Section D, follow steps 1, 2 and 3.
2.Remove the two lock nuts holding bearing retainer and remove retainer.
3.Remove old bearing.
55
