Maintenance and Cleaning
Lamp Replacement
When the life of the projection lamp draws to an end, LAMP REPLACE indicator lights yellow. If this indicator lights yellow, replace the projection lamp with a new one promptly.
This indicator lights yellow when the life of the projection lamp draws to an end.
TOP CONTROL
WARNING
POWERLAMP REPLACE
INPU
Allow the projector to cool, for at least 45 minutes before you open the Lamp Cover. The inside of the projector can become very hot.
CAUTION
For continued safety, replace with the lamp assembly of the same type.
Do not drop the lamp assembly or touch the glass bulb. The glass can shatter and may cause injury.
Follow these steps to replace the lamp assembly.
1 | Turn off the projector and disconnect the AC plug. Allow the |
|
| projector to cool at least for 45 minutes. |
|
2 | To remove the lamp cover, remove the screw with a screwdriver . |
|
3 | Remove two screws with a screwdriver and pull out the lamp |
|
| assembly by grasping the handle. |
|
4 | Replace the lamp assembly with a new one and tighten the two |
|
| screws back into the position. Make sure that the lamp |
|
| assembly is set properly. Replace the lamp cover and tighten |
|
| the screw. |
|
5 | Connect the AC Power Cord to the projector and turn on the |
|
| projector. |
|
6 | Reset the Lamp Replace Counter. |
|
| Refer to “Lamp Replace Counter” on the next page . | Screws |
|
|
Note :
Screw
Lamp Cover
Handle
Lamp Assembly
ORDER REPLACEMENT LAMP
Replacement Lamp can be ordered through your dealer. When ordering a projection lamp, give the following information to the dealer.
| • | Model No. of your projector | : |
| |
| • | Replacement Lamp Type No. | : |
| |
|
|
|
| (Service Parts No. 610 308 3117) |
|
|
|
|
|
|
|
|
|
|
|
|
|
42
