Eiki LC-SD12 To change the code of the projector, To change the code of the remote control

Setting

Remote control

This projector has two different remote control codes; the factory- set normal code (Code 1) and the secondary code (Code 2). This switching function prevents remote control interference when operating several projectors or video equipment at the same time.

When operating the projector in “Code 2,” both the projector and remote control must be switched to “Code 2.”

To change the code of the projector :

Set the remote control in the SETTING MENU to “Code 2.”

To change the code of the remote control :

Press and hold both the MENU and the IMAGE buttons on the remote control together for 10 seconds or more. After changing the code, make sure the remote control operates properly.

To return to the normal code (Code 1), operate both the projector and remote control in the ways above again.

Note :

–When battery of the remote control is replaced, the remote control code automatically returns to the normal code (Code 1).

Remote Control

Press and hold

MENU VOLUME- SELECT VOLUME+ the MENU and the

IMAGE buttons for 10

seconds or more.

D.ZOOM PAGE KEYSTONE NO SHOW

AUTO PC P-TIMER

IMAGE FREEZE MUTE

USB
This projector is equipped with the USB port for interactive operation	Key lock
between the projector and computer. Select either of the followings
as needed.
···· When using the PAGE ed buttons on the remote
control. ( ☞ P9 )
···· When controlling the projector with a computer.	Select Key lock to
This item is provided for future use. Not available now.	display this box.
	Choose one of
	these with the
	Point ed buttons
Key lock	and select [Yes] to
	activate it.
This function locks operation of the top control and the remote
control. It is useful to prevent operation by a third person.
···· Not locked.
···· Lock the operation of the top control.
To unlock, use the remote control.
···· Lock the operation of the remote control.
To unlock, use the top control.
If the top control accidentally becomes locked and you do not have	Factory default
the remote control nearby, disconnect the AC power cord to turn off
the power, and then while pressing the SELECT button, reconnect
the AC power cord. This will unlock the top control operation.
Lamp counter reset
This function is used to reset the lamp replace counter. When
replacing the projection lamp, reset the lamp replace counter by	Select Factory
using this function. Refer to page 43 for operation.	default to show
	this box. Select
	[Yes] to activate it.
Factory default
This function returns all setting values except for the lamp counter to
the factory default settings.

38