Eiki LC-SD12 owner manual Basic Operation, Turning On the Projector, Turning Off the Projector

Complete peripheral connections (with a computer, VCR, etc.) before turning on the projector.

Basic Operation

Turning On the Projector

1

2	Connect the projector's AC Power Cord into an AC outlet. The
	POWER indicator flashes in a moment and then turns red.
3	Press the POWER ON-OFF button on the top control or on the
	remote control. The POWER indicator turns green, and the

cooling fans start to operate. The starting display appears on the screen and the count-down starts.

26

–The starting display disappears after 30 seconds.

–The starting display can be changed. ( ☞ "Capture " P36 )

4	After the count-down, the input source that was selected last
	and the Lamp mode status appear on the screen.

Selected Input Source and Lamp Mode

Lamp mode

( ☞ " Lamp mode " P37 )

Turning Off the Projector

1	Press the POWER ON-OFF button on the top control or on the
	remote control, and the message " Power off? " appears on the
	screen.
2	Press the POWER ON-OFF button again to turn off the
	projector. The POWER indicator starts to flash red and
	continues while the cooling fans are operating. (for approx. 90
	seconds)
3	When the projector is cooled down enough to be turned on
		Message disappears after 4 seconds.
	again, the Power indicator turns red again. Then you can

disconnect the AC power cord.

TO MAINTAIN THE LIFE OF LAMP, ONCE YOU TURN

PROJECTOR ON, WAIT AT LEAST 5 MINUTES BEFORE

TURNING IT OFF.

DO NOT DISCONNECT THE AC POWER CORD WHILE

COOLING FANS ARE RUNNING OR BEFORE POWER

INDICATOR LIGHTS RED. OTHERWISE IT WILL RESULT IN

SHORTENING LAMP LIFE.

Note :

–When the Power Management function is ON, the projector detects signal interruption and automatically turns off the projection lamp. ( ☞ P 37 )

–The projector cannot be turned on during the cooling period with the POWER indicator flashing red. You can turn it on again after the POWER indicator lights red.

–Do not use the projector for more than 24 hours continuously. Turn off the projector at least once in 24 hours and give it a rest. Continuous use may result in shortening the lamp lifetime.

–This projector detects internal temperature and automatically controls the running speed of the cooling fans.

–If the WARNING indicator flashes or lights red, see “Warning Indicator” on page 39.

Basic Operation

17