To connect to other Meridian 500
One unit will then be designated
Series equipment
as the controller, and display:
Con.
● Connect one of the COMMS sockets on the back panel of the |
CD player to one of the COMMS socket on another 500 Series |
unit, using the 500 comms lead provided with the other unit. |
This is the unit that will respond to the remote.
All the other units will be configured
The sequence in which you connect the units is not important.
as
N.Con.
the CD player
COMMS | COMMS |
Then configure the units with the following automatic setup procedure:
●Switch all the units to standby.
●Press Clear on the remote.
Your system is now set up and ready for use.
●If for any reason the automatic setup does not give the configuration you want, restore the default operation by selecting Type 1 as described in To connect to Meridian 600 or 200 Series equipment, page 22.
●If you want to change the automatic setup configuration refer to the Meridian 500 Series User Guide.
Note: Do not, under any circumstances, connect any equipment other than Meridian 500, 600, or 200 Series to the socket
Setting up
Each unit will display:
Auto
marked COMMS on the back of the CD player.
20