Meridian America Single--channel, RGB/DVI transmitter & Receiver Troubleshooting, Problem, Action

5.0Troubleshooting

Below is a listing of several problems that may arise during the installation & operation of the modules. If you are having difficulty installing or operating the modules please refer to this list below.

Problem:	Module does not fit in chassis slots
Action:	Check module orientation. Meridian “Globe” must be oriented on the top left hand side of the
	module
Problem:	Make sure the card guides in the chassis are aligned with the extrusion on the module
	Card power LED does not light when power to the module/subrack is applied or power indicator
	turns on and off
Action:	Check power supply to ensure that it is plugged in and turned on. If flashing continues, move
Problem:	module to another chassis or location in the same chassis, if available.
	No Video
Action:	1 - Check the modem locations to ensure that the RGB-T module is connected to the video
	source (computer, camera, etc) while the receiver module (RGB-R) is connected to the video
	output device (monitor, etc.)
	2 – Check to ensure that the modules are in the proper mode of operation (RGB or DVI) –
	onboard switch #1 (see section 3.4)

If the problem still persists after reviewing the above items, please contact Meridian technical support (516-285- 1000).

Appendix 1 – Supported Video Resolutions & Refresh Rates

The table below lists the presently-supported video resolutions and refresh rates. Meridian continues to expand the supported variations and will update this list as they become available.

If you have any questions about other resolution/refresh rates, please call our technical service personnel.

	700 Elmont Rd, Elmont, NY 11003, Tel: 516-285-1000; Fax: 516-285-6300
	www.Meridian-tech.com
Page 8	3/07 Rev 1.2