CONFIGURATION OF THE MS700I/MS720I WITH “MX”
To perform matching procedure refer to page 18.
Once the transmitter is assigned an ID number, configure the S700i/MS720i to accept RF communication. Although the changes made in this section effect the receiver, the MS6130 performs all scanning.
1.Scan the following bar code to enter the receiver’s program mode. (The MS700i/MS720i will beep three times):
Enter/Exit Program Mode for the Receiver
01 2 3 4 5
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| 6 6 6 6 6 |
|
|
|
|
|
| 7 | ||||||||
|
|
|
|
|
| |||||||||||||
2.Enable the RF interface by scanning the following bar codes in order:
R 0 1
L P 1
H H 1
3.Exit program mode by scanning the bar code in Step 1 again.
4.Proceed to the procedure on the next page.
7
