Metrologic Instruments MS6130 MX003 manual

CONFIGURATION OF THE “MX” TO THE RS-232, LIGHT PEN OR KEYBOARD WEDGE HOST SYSTEM

To perform matching procedure refer to page 18.

The light pen, RS-232 and Keyboard Wedge parameters marked with an asterisk ( * ) in the charts are the default settings of the “MX”. The charts are in the Default Settings of the Transmitter and “MX” Receiver section of this guide. To communicate with a host system properly, program the “MX” to match the host system’s requirements. However, the Enter/Exit Program Mode bar code in the MS4120 Programming Guide will not cause your “MX” to enter or exit program mode. Scan the Enter/Exit Program Mode for the Receiver bar code in the following procedure. Once the MS6130 is assigned an ID number, configure the “MX” to the correct communication protocol.

1.Scan the following bar code to enter program mode. (The “MX” receiver will beep three times):

Enter/Exit Program Mode for the Receiver

01 2 3 4 5

6 6 6 6 6 7

2.Scan the following bar code to confirm the receiver is using the original factory settings.

Recall Defaults

D F 1

3.Scan the appropriate communication options in the MS4120 and MS951 Programming Guides.

4.Exit program mode by scanning the following bar code. (The “MX” receiver will beep three times):

Enter/Exit Program Mode for the Receiver

01 2 3 4 5

6 6 6 6 6 7

10