![](/images/new-backgrounds/1133133/13313337x1.webp)
To cancel mute, there is two alternative; the first one is pressing to " " button, thus vol-
ume is set to the preceding value, and the second one is increasing the volume level, thus it starts at the minimum level to in- crease. By decreasing the volume level in mute state, mute will not be ignored, only the volume level will decrease. If mute canceled after decreasing the volume level, the vol- ume will valid with the decreased level.
No-Signal
It is displayed in the middle of the screen when no valid signal detected. It shows the remained time for the switching to the
After an Remote Control command (if No- Signal Timer is active) the timer stops and if no signal detected again the timer is initial- ized to 5 minutes and starts 3 seconds later again to count down.
It is not valid in AV mode.
Blue Background During No-Signal
In case, no valid signal is detected AV mode. Blue Background is
Volume Bar
It is displayed in the lower middle of the screen. When a volume command is re-
ceived (pressing or
by Remote Control or Front panel) and no menu is ac- tive, it stays on the screen for 3 seconds, af- ter the last volume command or until an- other command is received in between.
AV Modes
By pressing the “AV“ button you can switch your TV to AV modes (except being in Tele- text). Pressing this button consecutively will switch the TV in one off the AV modes: AV1, AV2, RGB, SVHS or FAV (Front AV).
AV1 supports the RGB mode. But if there is some colour problem in AV1 or AV2 modes, please force the AV mode to RGB or SVHS mode.
In order to quit the AV mode press the “TV”, digit buttons, “P+” /
Teletext
Teletext is an information system that dis- plays text on your TV screen. Using the Tele- text information system you can view a page of information on a subject that is available in the list of contents (index).
On screen display is not available in text mode.
Contrast, brightness or colour control is not available, but volume control is available in text mode.
To operate Teletext
•Select a TV station on which Teletext is being transmitted.
•Press (TELETEXT) “TEXT” button. Usually the list of contents (index) is displayed on the screen.
To select a page of Teletext
•Press the appropriate digit buttons for the required Teletext page number.
The selected page number is displayed at the top left corner of the screen. The Teletext page counter searches until the selected page number is located, so that the desired page is displayed on the screen.
•Press “P+” button to move the Teletext screen forward one page at a time.
•Press
- 17 -