MicroBoards Technology GX Auto Printer user manual Windows Vista Hardware Installation

MICROBOARDS TECHNOLOGY, LLC GX AUTO PRINTER

Windows Vista Hardware Installation

The Microboards GX Auto Printer Installer should always be run when logged in as user with full Administrator rights. This is required for the driver pre-installation to be successful. Once the GX Auto Printer is plugged into the PC via the USB connection, the hardware will automatically be found and installed on your PC.

During the driver pre-installation, you may need to verify that you would like to install the drivers.

If the Installer is run by a user without full Administrator rights, or you do not verify that the drivers should be installed, the hardware will need to be installed using the Hardware Wizard. Please follow the directions below.

Windows XP Hardware Installation

The Windows Found New Hardware Wizard will appear during any installation, including when using the Installer. Please follow all directions in the order in which they appear when using the Installer.

Install the GX-300HC cartridge and turn on power to the GX Auto Printer.

Insert the Microboards GX Auto Printer CD into a drive in your computer. Follow the instructions provided by the Installer. Connect the GX Auto Printer to the PC only when you are prompted to.

Once the GX Auto Printer is connected, the operating system will next display the following screen:

1. Select No, not this time and click	3. Click Continue Anyway.
Next.

4. Click Finish for the next screen.

2.Click Next.

9