Section 3: Installing the M54E2

Installing the SIMMs

To install the SIMMs, locate the memory banks on the system board and perform the following steps:

1.Hold the SIMM so that the notched edge is aligned with the notch on the SIMM socket (Figure 3-1).

2.Insert the SIMM at a 45 degree angle.

3.Gently push the SIMM into an upright position until it locks into place (past the release tabs).

Figure 3-1: Installing a 72-Pin SIMM

Removing SIMMs

To remove SIMMs, follow the steps below:

1.With both thumbs (or fingers), press the release tabs away from the socket.

2.With the SIMM free from the release tabs, lift the module up and place in an anti-static bag or package.

M54E2 System Board Manual

3-5