Section 5: EISA Utility

Step 2: Add or Remove Boards

When you select Step 2, the utility scans and locates the EISA boards installed. This section allows you to add or remove any EISA, PCI, and ISA Plug and Play peripherals. Beyond physically adding or removing the boards, it is important that you run this utility in order for your system to run prop- erly.

When you select “Step 2: Add or Remove Boards,” the following screen (Figure 5-3) will appear.

Figure 5-3 Add or Remove Boards Screen

Press <Insert> to add the boards that could not be detected or boards you plan to install. After you press the <Insert> key, the following screen (Figure 5-4) will appear.

You will need to have the configuration disks that came with each of the add- on cards you are installing. Insert the configuration disk for the peripheral you are installing and press <Enter>.

5-4

M54E2 System Board Manual