BIOS Setup
the sleep state. Available options are:
Single LED The power LED blinks to indicate the sleep state without changing its color.
Dual LED The power LED changes its color to indicate the sleep state.
AfterAC Power Lost
This setting specifies whether your system will reboot after a power failure or interrupts occurs. Available settings are:
Power Off Leaves the computer in the power off state. Power On Reboots the computer.
Last State Restores the system to the status before power failure or interrupt occurs.
PMWake Up Events
Press <Enter> to enter the
IRQ [3-7,9-15],NMI/IRQ 8 Break Suspend
This setting enables/disables the monitoring of the specified IRQ line. If set to Enabled, the activity of the specified IRQ line will prevent the system from entering power saving modes or awaken it from power sav- ing modes. Setting options: Disabled, Enabled.
Note: IRQ (Interrupt Request) lines are system resources allocated to I/O devices. When an I/O device needs to gain attention of the operating system, it signals this by causing an IRQ to occur. After
