Moisture plus
To evaporate residual moisture
If there is still water in the steam injection system at the end of a programme or if the programme is cancelled, you will be prompted to evaporate the residual moisture.
This prompt will appear
–when the appliance is switched on,
–when selecting "Moisture plus", or
–when selecting an automatic programme that uses Moisture plus.
Select "Cancel" to cancel the process or "OK" to start it.
The residual moisture evaporation process
The oven will heat up to approx.
150 °C, and the residual water in the oven cavity will evaporate.
How long this takes will depend on the amount of water in the system.
Steam will condense on the door and the oven cavity, and the moisture will then need to be wiped off after the oven has cooled down.
It is best to start the evaporation process straight away so that only fresh water can be used during the next cooking programme.
To start the residual moisture evaporation process
Confirm the prompt "Evaporate residual moisture" with OK.
The evaporation process will start immediately. The display will show the approximate time remaining.
43
