Changing the door hinging
Changing over the doors
Pull hinge pin together with disc and adjustable foot upwards and off.
Remove cover cap .
Undo screws and take hinge plate off.
Undo the screw of hinge part on hinge plate slightly. Fit it into the hole opposite in hinge plate and tighten up the screw.
Refit cover cap in the other hole.
Remove cover and fit it into the holes on the opposite side.
Screw hinge plate into position on the opposite side using the two outer long slots only. To make it possible to align the door later, do not replace the centre screw at this stage.
Important. Screw the adjustable foot
into hinge pin as far as it will go.
Refit hinge pin together with disc
and adjustable foot . Important. The notch at the bottom of the hinge pin should face towards the back.
Place the door onto hinge pin .
Close the lower appliance door.
45