Changing the door hinging
Refitting the handles
Please make sure you follow the instructions below carefully when you refit the handles. The door seal will be damaged if the handle is fitted incorrectly.
Loosely attach the handle to the opposite side of the door with the two front screws .
Mounting plate must be positioned on the side of the door so that when the door is closed it is flush with the side of the appliance.
If this is not the case,
tighten both grub screws with a suitable allen key until mounting plate
lines up correctly.
Then tighten all 4 screws .
Slide the side section of the handle
into the guides on the mounting plate until it clicks into place.
It is important to check that the side section of the handle does not come into contact with the door seal when opening the door, as this would damage the door seal permanently.
If, after you have refitted the handle, you find that the side section does touch the door seal when the door is opened:
Realign mounting plate with grub screws until the mounting plate and the side section of the handle are at the correct angle and the side section does not touch the door seal when the door is opened.
47
