Programming
You can change the standard settings of your hob.
With the hob switched off, touch the hob ON/OFF sensor and the booster sensor B at the same time, until P (Programme), S (Status) and numbers appear in the cooking zone displays. This shows the current setting.
To set the programme:
Touch the sensor for the front left cooking zone.
The relevant number will begin to flash.
Touch the + or - sensor to set the required programme.
To set the status:
Touch sensor for the front right cooking zone.
The relevant number will begin to flash.
Touch the + or - sensor to set the required status.
To store the new settings in memory, touch the B sensor until the displays go out.
If you do not wish to store the settings in memory, touch the ON/OFF sensor until the displays go out.
Programme | Status* | Setting | |||
P | 0 | Demonstration mode and factory | S | 0 | Demonstration mode on |
|
| default settings | S | 1 | Demonstration mode off |
|
|
| |||
|
|
| S | 9 | Factory default settings |
|
|
|
|
| reinstated |
|
|
|
|
|
|
P | 1 | Keypad tone when a sensor is | S | 0 | Off |
|
| touched | S | 1 | On |
|
|
| |||
|
|
|
|
|
|
* The factory default settings are shown in bold.
30
