Installation

Electrical connection

,This installation should be performed by an experienced and qualified technician, in accordance with local codes and regulations.

The washer comes with a power cord without a plug.

The machine is supplied as standard for connection to a 208 V, 60 Hz, 20 A, 2-phase electrical supply*.

For extra safety it is advisable to install a residual current device (RCD) with a trip current of 30 mA.

The machine must only be connected to the voltage and frequency shown on the data plate.

,*To convert the machine to another electrical connection, please read the converting manual on the wiring diagram inside the washer. The conversion must be performed by a Miele Service Technician. Additionally the "Heating level" setting must be adjusted.

,Do not install devices to automatically turn the washer off, i.e. a clock timer.

For Canada only:

If the machine is hard wired, two 20 A circuit breakers must be provided on-site. Switches with a contact gap of more than 3 mm are valid as separators. All components must be CSA or UL approved.

56

Page 56
Image 56
Miele PW 6065 manual Electrical connection, For Canada only